Managed sourcing from Bangladesh, for export and for buyers at home
Get it sourced

Machinery and handling · Pumps

Fire pump supplier in Bangladesh

Roptan is a fire pump supplier in Bangladesh for high-rise buildings, factories, hospitals and warehouses. Send the hydraulic calculation: we source electric, diesel and jockey pump sets from verified sellers, check listing and test curves, and deliver, installed by the seller.

  • Verified sellers
  • Checked before it ships
  • Delivered by Roptan

Get fire pumps sourced

Prefer to deal with suppliers yourself? Post it on the requirement board

Buying fire pumps in Bangladesh

A fire pump feeds a building's hydrants and sprinklers when the fire system calls for water. It is a centrifugal or positive displacement pump, driven most often by an electric motor or a diesel engine, and it starts on its own when system pressure falls below a set point. Buyers include high-rise developers, factories, hospitals, hotels, warehouses and shopping malls.

A fire pump supplier in Bangladesh has to deliver what the fire safety plan approved by the Fire Service and Civil Defence describes, and prove it on test. Roptan takes your hydraulic calculation, sources from verified sellers, checks the listing and factory test curve against the exact model, and delivers.

Kinds of fire pump

Horizontal split case pumps

The pump for larger flows; the top half of the casing lifts off for inspection and impeller change. It needs water above the pump: NFPA 20 does not allow it to run on suction lift.

Vertical turbine pumps

The pump bowls hang below the driver in the water itself. The one type NFPA 20 permits to draw from a source below the pump, such as an underground cistern or a well; the lowest bowl must stay submerged at the lowest water level.

End suction and vertical inline pumps

End suction pumps suit smaller buildings and lower flow demands. Vertical inline pumps fit plant rooms and retrofits with little floor space.

Diesel engine driven pumps

Runs without mains power, as standby or main pump. Each engine needs two independent starting energy sources, and its controller must be listed too.

Jockey pumps

A small pump that holds system pressure so small leaks do not start the main pump. Its flow stays below one sprinkler's, so an open sprinkler still starts the main pump.

What a fire pump supplier in Bangladesh needs from you

Hydraulic calculation
Rated flow and net pressure from the approved sprinkler and hydrant calculation. The pump is chosen from that point, not from the floor count.
Water source
Tank, underground reservoir or well, with the lowest water level and the suction pipe run. The source decides between a split case and a vertical turbine pump.
Drivers
Electric main pump, diesel standby and jockey, as the plan sets out. Each driver must cover the full power the pump can demand, including flow beyond the 150 percent point.
Governing standard
Name it in the enquiry. NFPA 20:2025 is the current edition; tenders written to other codes can set different limits.
Listing
Say whether your design or insurer requires UL listed or FM approved pumps and controllers; it is their requirement to set.
Relief valve and controllers
Each pump needs a circulation relief valve listed for fire pump service, and controllers listed for fire pump service, factory assembled and tested.

Standards, approvals and tests for fire pumps

NFPA 20:2025
Fire pump installation and performance. Churn pressure must not exceed 140 percent of rated pressure, and the pump must give 150 percent of rated flow at no less than 65 percent of rated pressure.
UL listing or FM approval
NFPA 20 issues no listings itself; UL or FM list the pump, the controller and the diesel controller. The listing must cover the exact model offered.
NFPA 25
Inspection and testing of water-based fire protection systems in service, the companion to NFPA 20, jockey pumps included.
Fire Service and Civil Defence
Clears the fire design of a high-rise before it can be approved, and issues the yearly fire licence after its inspector checks the equipment is installed and working and a water reserve is available.

What moves the price of a fire pump

  • Rated flow and pressure, which set pump size, speed and driver power.
  • Listing: listed or approved pumps with matching listed controllers usually cost more than unlisted pumps.
  • Diesel driver: engine size, its two starting energy sources and its listed controller.
  • Casing: a split case or vertical turbine pump for larger flows and deep sources.
  • Scope: pump room pipework, valves, the flow test arrangement and the field acceptance test.

Lead times and delivery

A set from a seller's stock moves faster than one built to your rating. A listed set imported to order, a large split case or vertical turbine pump, a diesel driver or a witnessed factory test usually adds time. Roptan confirms the delivery date and any minimum order in the quote.

Roptan delivers to your site anywhere in Bangladesh. Where installation is in scope, the seller sets the pumps and drivers in the pump room, connects the pipework and relief valves, wires the controllers and runs the field acceptance test at churn, rated and 150 percent of rated flow, reading suction and discharge pressure together. Handover includes both test records, listing papers, manuals, warranty and a VAT invoice (Mushak 6.3).

What we check for this order

  • Listing matches the modelWe check the pump, controller and diesel controller listings cover the exact models offered, not only the range.
  • Factory test curveWe check the curve shows churn, 100 and 150 percent flow points within NFPA 20 limits before the set ships.
  • Rating against the calculationWe check rated flow and pressure match the approved hydraulic calculation, and the driver covers flow beyond 150 percent.
  • Diesel startingWe check each diesel engine has two independent starting energy sources and a controller listed for fire pump service.

Questions buyers ask

Why does our fire pump start on its own?

Usually a leak or a jockey pump fault. The jockey pump holds pressure so small leaks do not start the main pump; if it fails, or the leak outruns it, pressure falls and the main pump starts. Find the leak and check the jockey pump settings.

Is UL or FM listing required by law in Bangladesh?

Usually the requirement comes from the fire design or your insurer, not from a law. The design and the fire safety plan approved by the Fire Service and Civil Defence set what is needed. If listed equipment is specified, the pump, the controller and the diesel controller must each be listed.

What is a churn test?

Running the pump against a closed outlet, at no flow. Under NFPA 20 churn pressure must not exceed 140 percent of rated pressure. The field test then runs the pump at rated flow and at 150 percent of rated flow too.

Who approves the fire pump installation in Bangladesh?

The Fire Service and Civil Defence approves the fire safety plan, and the pump set must match it. Under the Fire Prevention and Extinguishing Act 2003, high-rise designs need fire service clearance, and an inspector checks the equipment works before the yearly licence.

How soon will I hear back about pumps?

Within 48 hours of a complete requirement, with a price and a delivery date. A requirement is complete when it has the model or specification, where it is needed and by when.

Who do I deal with?

With Roptan, when Roptan manages the order: we buy from the verified seller and deliver to you. With the supplier directly, when you post on the requirement board and choose a quote yourself.

Other pump products

Each product type has its own page as it is published; until then its card opens the category form.

All pumps