Managed sourcing from Bangladesh, for export and for buyers at home
Get it sourced

HVAC and cold chain · Dehumidifiers

Pool dehumidifier supplier in Bangladesh

Roptan works as your pool dehumidifier supplier in Bangladesh. Tell us the pool area, water temperature, hall size and how busy the pool gets: we source heat recovery units from verified sellers, check the coating and the rating basis, and deliver.

  • Verified sellers
  • Checked before it ships
  • Delivered by Roptan

Get pool dehumidifiers sourced

Prefer to deal with suppliers yourself? Post it on the requirement board

Buying pool dehumidifiers in Bangladesh

A pool dehumidifier removes the moisture that evaporates from an indoor pool and keeps the hall air from turning wet and corrosive. Most are condensing heat pump units, and many return the heat they recover to the hall air or the pool water. In Bangladesh they serve indoor pools in hotels, clubs and some schools, where monsoon air adds to the moisture the pool gives off.

Pool air carries chlorine compounds that corrode coils, casings, ducts and fixings, so a unit built for an office will not last. As your pool dehumidifier supplier in Bangladesh, Roptan asks verified sellers for capacity worked from your pool, a coating system stated in writing and the safety report, then delivers.

Kinds of pool dehumidifier

Condensing heat pump units

A refrigerant circuit condenses moisture out of the hall air, and the heat it takes out can be reused. One maker's guide calls it the type to choose for indoor pools.

Heat recovery to hall air

The heat taken out with the moisture is returned to the hall air. Choose it where the hall needs warming.

Heat recovery to pool water

The recovered heat warms the pool water instead, and some units switch it between water and air as demand changes. Choose it where pool heating is a large running cost; recovery figures in brochures are the maker's own.

Free-standing units

Set in or beside the hall with little or no ductwork. Choose them for small pools where a plant room is not available.

Ducted units

Placed in a plant room and connected by ducts to recirculate hall air. Choose them for larger halls and where the unit should be out of sight.

How to specify a pool dehumidifier

Humidity set point
A municipal natatorium guide recommends 50 to 60 percent RH; one maker suggests 55 percent, plus or minus 5. State the figure you want held.
Hall air temperature
One municipal guide suggests hall air about 1 to 2 K warmer than the water, since air warmer than the water cuts evaporation, but no higher than 30 °C for comfort. Give both temperatures.
Pool and bather load
Makers choose the unit from the pool size, the hall volume and the number of swimmers. Evaporation rises with the water area, bather activity and the gap between water and air temperature. Give all of these.
Corrosion protection
Ask the seller to state the ISO 9223 corrosivity category or ISO 12944-2 environment the coil, casing and fasteners were coated for.
Ducts and fixings
Chlorine in pool air also attacks blockwork, mortar, metal doors and light fittings, so ducts, hangers and grilles in the hall need the same care.
Fresh air
Purging with fresh air clears chlorine odour but costs energy. Ask how the design balances outdoor air with dehumidification and heat recovery.
Supply
Large units usually run on three phase at 50 Hz, nominally 380 to 400 V. Check the data plate against the supply.

Coatings, safety and paperwork for pool units

ISO 9223 and ISO 12944-2
Classify the corrosivity of the atmosphere and the environment for steel paint systems. Ask for the category chosen and the coating system in writing.
ISO 13788:2012
The calculation of internal surface temperature to avoid condensation on walls and glazing. Ask the designer whether the hall was checked with it.
Safety test report
IEC 60335-2-40 covers dehumidifier safety, but its title says household and similar appliances. For a large unit, ask which standard the report cites.
EN 378-1:2016+A1:2021
Safety and classification rules for refrigerating systems and heat pumps, relevant to the refrigerant circuit of a heat pump pool unit.
EN 12102-1:2022
How the sound power of compressor dehumidifiers is determined. The 2017 edition was withdrawn in 2022, so ask for a figure to the current one.

What moves the price of a pool dehumidifier

  • Capacity worked from the water area, hall volume and bather load.
  • Coating for a higher corrosivity category on the coil, casing and fasteners.
  • Heat recovery to air, to water or both, and the pipework for water.
  • Ductwork and its fixings in the hall, built for chlorinated air.

Lead times and delivery

No typical lead time is given here. Pool units are usually imported and often built to a duty, so the maker, shipping and clearance at Chattogram set much of the time; a model in stock arrives sooner. Special coatings, water heat recovery, ducting and coordination with the pool contractor can add time. Roptan confirms the dates and any minimum in the quote.

We deliver to site anywhere in Bangladesh. The seller sets the unit, connects ducts, drain, power and any pool water circuit, and commissions it. Hall humidity and temperature are read on instruments calibrated by an ISO/IEC 17025 accredited lab. Handover includes the coating system in writing, the safety test report, manuals, warranty papers and a VAT invoice (Mushak 6.3).

What we check for this order

  • Coating in writingWe ask for the corrosivity category and coating system for the coil, casing and fasteners, since chlorinated air attacks bare metal.
  • Capacity basis shownWe ask each seller to state the water area, temperatures and bather load the capacity was worked from.
  • Safety and refrigerantWe ask which standard the safety test report cites, and that the refrigerant circuit follows EN 378-1.
  • Calibrated readingsWe ask for hall humidity and temperature on calibrated instruments at commissioning, so the set point is shown to hold.

Questions buyers ask

What humidity should a pool hall hold?

A municipal natatorium guide recommends 50 to 60 percent RH, and one maker suggests 55 percent plus or minus 5. Agree one set point with the seller, write it into the order and have it shown on calibrated instruments at commissioning.

Why does our pool hall smell of chlorine?

Chlorine treatment forms chloramines, which cause the strong odour. Fresh air purges them but costs energy, which is why pool systems balance outdoor air with dehumidification and heat recovery. Ask the seller how much fresh air the design brings in.

Can the unit help heat the pool water?

Yes, if it is built for water heat recovery. The heat taken out with the moisture can go back to the hall air or the pool water. Treat a brochure's recovery percentage as the maker's own figure, not a rating.

How is a pool dehumidifier sized?

From the evaporation and the hall. Evaporation rises with the water area, bather activity and the gap between water and air temperature, and the maker also needs the hall volume and the number of swimmers. Give the seller those figures and ask them to show how the capacity was worked out.

How soon will I hear back about dehumidifiers?

Within 48 hours of a complete requirement, with a price and a delivery date. A requirement is complete when it has the capacity, where it is needed and by when.

Who do I deal with?

With Roptan, when Roptan manages the order: we buy from the verified seller and deliver to you. With the supplier directly, when you post on the requirement board and choose a quote yourself.

Other dehumidifier products

Each product type has its own page as it is published; until then its card opens the category form.

All dehumidifiers