Managed sourcing from Bangladesh, for export and for buyers at home
Get it sourced

HVAC and cold chain · Cold rooms

Condensing unit supplier in Bangladesh

Order through Roptan, your condensing unit supplier in Bangladesh. Tell us the room temperature, load and site heat: we source the unit from a verified seller, check its capacity at your ambient and its refrigerant status, and deliver.

  • Verified sellers
  • Checked before it ships
  • Delivered by Roptan

Get condensing units sourced

Prefer to deal with suppliers yourself? Post it on the requirement board

Buying condensing units in Bangladesh

A condensing unit joins at least one electrically driven compressor and a condenser in one product. Connected to an evaporator and an expansion device, it cools a room down and holds it at low or medium temperature. Room builders, food businesses, pharmacies and cold stores buy them.

As a condensing unit supplier in Bangladesh, Roptan writes your duty into one brief: room temperature, load, site ambient and refrigerant. We check the rating sheet at your conditions, the refrigerant's phase-out status and the service support, then compare quotes from verified sellers.

Kinds of condensing unit

Hermetic and semi-hermetic units

The motor sits inside the refrigerant circuit. A hermetic motor cannot be maintained in place, so a failed motor means a new compressor; a semi-hermetic unit is also called accessible hermetic. Ask what can be repaired on site before you choose.

Open drive units

An external motor that can be serviced without removing the refrigerant, at the cost of a shaft seal that can leak. Choose one where on-site motor service matters.

Piston, scroll and screw units

All positive displacement compressor types offered as condensing units. Compare them on rated capacity and efficiency at your duty, not on compressor type alone.

Parallel units

Several compressors on one frame. Ask the seller to state how the unit behaves when the load falls and when one compressor stops, and whether that is what your room needs.

Air and water cooled units

Heat goes to air across a coil, or to water, including evaporative condensers. Air cooled units need open airflow; water cooled units need a steady water supply.

How to brief a condensing unit supplier in Bangladesh

Duty class
Say low temperature (freezer) or medium temperature (chill). The EU rating rule, a reference here, puts them at minus 35 °C and minus 10 °C saturated evaporating temperature; a unit is rated for one duty or the other.
Capacity at your ambient
Catalogue capacity is often given at a 32 °C reference ambient, and Dhaka has recorded over 40 °C. Ask for capacity at your site's peak, in kW or TR (1 TR = 3.517 kW).
Load
Give room size, daily intake, door use and set point, or ask for the seller's heat load calculation, so capacity is matched, not guessed.
Refrigerant
Name the refrigerant you want, or ask for options and their status. Avoid HCFC-22 for a new unit; R-404A is a high-GWP blend being phased out.
Power supply
State the supply, three phase or single phase at 50 Hz, and where the unit will stand.
Fan motors
Ask for efficient condenser fan motors, such as electronically commutated types; the US walk-in rule, a reference and not a Bangladesh requirement, names them for smaller units.

Standards for condensing units

EN 13215:2016+A1:2020
Rating conditions, tolerances and how makers present condensing unit performance data. The plain 2016 edition is withdrawn, so ask for data to the amended edition.
EN 13771-2:2017
Performance testing of condensing units: refrigerating capacity, power absorbed, refrigerant mass flow and coefficient of performance.
EU Regulation 2015/1095
EU ecodesign rules for condensing units, with a seasonal efficiency measure that reflects load and ambient through the year. Here it is a reference, not a rule.
Montreal Protocol and Kigali Amendment
HCFC consumption in Bangladesh falls to zero from 1 January 2030, with a servicing tail to 2040. Bangladesh ratified Kigali on 8 June 2020 and runs ODS and HFC licensing systems.
EN ISO 5149-4:2025
Operation, maintenance, repair and refrigerant recovery. It replaced EN 378-4, withdrawn on 31 December 2025.

What moves the price of a condensing unit

  • Capacity at your duty and ambient, not the catalogue figure.
  • Compressor type, and whether it can be serviced on site.
  • Refrigerant, and the future supply of its gas.
  • Air or water cooling, and a condenser sized for your heat.
  • Fan motor type and controls that cut running cost.
  • Standby: a second unit, or a parallel unit, and what the seller says happens if one compressor stops.

Lead times and delivery

No sourced lead time covers every unit. It is usually shorter for common capacities and refrigerants held by local distributors, and longer for low temperature or large units, parallel or water cooled builds, less common refrigerants or units imported to order. Roptan confirms the dates and any minimum order in the quote.

We deliver the unit to your site anywhere in Bangladesh. The seller places it where air or water reaches the condenser, pipes and wires it to the evaporator, pressure tests, evacuates and charges it. Ask for the room's pull-down to set point and its power-off hold time. Papers include the rating sheet, warranty and a VAT invoice (Mushak 6.3).

What we check for this order

  • Rating sheet at your conditionsWe check the quoted capacity is at your evaporating temperature and site peak ambient, with data to EN 13215, not a headline figure.
  • Refrigerant statusWe have the refrigerant named and check it against the HCFC phase-out and Bangladesh's HFC licensing.
  • ServiceabilityWe ask what can be repaired on site and where spare compressors and parts are held in Bangladesh.
  • Pull-down and hold recordWe ask for a logged pull-down to set point and a power-off hold time before handover.

Questions buyers ask

Why does my cold room warm up on hot afternoons?

Often because the unit was sized at a catalogue reference ambient, commonly 32 °C, while your site runs hotter, and output falls as the outdoor temperature rises. Ask for capacity at your peak ambient, keep the condenser's airflow clear and have the charge checked.

Which refrigerant should a new unit use?

Not HCFC-22: under the Montreal Protocol its consumption in Bangladesh falls to zero from 1 January 2030. R-404A is a high-GWP blend being phased out. HFCs are being phased down under the Kigali Amendment, which Bangladesh ratified in 2020, so ask each seller for options and their status.

What is the difference between low and medium temperature units?

They are rated at different evaporating temperatures: low temperature at minus 35 °C for freezers, medium at minus 10 °C for chill rooms, under the EU rating rule. A unit is rated for one duty or the other, so say which you need.

How do I convert TR to kW?

One tonne of refrigeration (TR) is 3.517 kW. Ask for capacity in kW at your evaporating temperature and site ambient; a TR figure without those conditions says little about your room.

Can a hermetic compressor be repaired?

Usually not in place: its motor is sealed inside the refrigerant circuit, so a failure usually means replacing the compressor. Open drive compressors can have the motor serviced without degassing, but can leak at the shaft seal.

How soon will I hear back about cold rooms?

Within 48 hours of a complete requirement, with a price and a delivery date. A requirement is complete when it has the capacity, where it is needed and by when.

Who do I deal with?

With Roptan, when Roptan manages the order: we buy from the verified seller and deliver to you. With the supplier directly, when you post on the requirement board and choose a quote yourself.

Other cold room products

Each product type has its own page as it is published; until then its card opens the category form.

All cold rooms